Manual

• Is your recorder ready?
• Refer to "INSTALLATION GUIDE" and finish the
necessary preparations.
• Turn on the connected equipment such as aTV or
audio system and select the input from the recorder.
• Turning the power on
(This owner's manual instructions are based on
the premise that all proper connections have been
completed and theTV is turned on.)
Press ON/STANDBY on the front panel of the
recorder or on the remote control.
ON/STANDBY button
• Loading a disc
Check disc compatibility beforehand (_ page 6, 7)
and use a proper playable disc.
Caution
• Keep your fingers well clear of the disc tray. Neglecting this
may cause serious personal injury. Keep a close watch on
children.
• Do not use a cracked, deformed, or repaired disc.
1 Open the disc tray.
Press ----.on the front panel or OPEN/CLOSE on
the remote control.
LED
When the power turns on, the LED on the front panel
illuminates.
After a few seconds, a start-up screen appears.
The following icon appears at the top right corner of
the screen.
e,g,
@
When this icon disappears, the recorder is ready to
operate. If the disc drive contains a disc, it takes a
little longer to start up.
• Viewing TV channels through this recorder
After turning the power on, the recorder will output TV
channel signals to the connected TV (also in the stop
mode).
You can select a desired channel by pressing the CH
button, or the number buttons.
A button
OPEN/CLOSE button
Insert a disc.
Disc without a cartridge
Insert with the playback side down.
There are two kinds of disc size. Place a disc to fit
the guide. If a disc is out of the guide, it may result
in damage to the disc or malfunction.
ocO
_lace a disc in the
inside hollow.
20