Manual

• Data cannot be recorded on a DVD-RAM disc.
• The disc is protected from deleting data.
-_ Set the write-protect tab to the opposite of
"PROTECT" (_ page 8).
• The disc is protected by a PC or the recorder.
-_ Disable the protection on the device which
protected the disc.
• The disc space is not sufficient.
-_ Delete unwanted data (_ page 47) or prepare a
new disc.
• The disc is not initialized.
-_ Initialize the disc (_ page 28).
• The disc may contain errors.
-_ Complete the physical format on the disc
(_ page 29).
• The physical format on the disc is not completed.
-_ Complete the physical format on the disc
(_ page 29).
• Timer programming cannot be completed.
• Clock setting has not been completed.
-_ Complete the clock setting (_ page 33,
"INSTALLATION GUIDE").
• The programs list is full.
-_ Cancel unwanted programs (_ page 44).
• When the power goes down, timer programs will be
deleted.
-_ Check the timer programs and set them again.
• The remote control does not work.
• The batteries in the remote control are exhausted.
-_ Replace all the batteries in the remote control
(_ page 18, "INSTALLATION GUIDE").
• The light emitter of the remote control is not pointed
at the receptor of this recorder.
-_ Point the emitter of the remote control at the
receptor of this recorder.
• The receptor of this recorder is located too far away
from the remote control.
-_ Operate the remote control within 7 meters (23 ft)
from the receptor of this recorder.
• There are obstacles between the remote control and
this recorder.
-_ Remove any obstacles.
• The receptor is disturbed by sunlight or fluorescent
light.
-_ Change the place of this recorder or shield the
light.
• The remote mode is not appropriate.
-_ Adjust the remote mode of the remote control and
this recorder (_ page 44, "INSTALLATION
GUIDE").
• The setting of the TV/DVD selector is not correct.
-_ Set the TV/DVD selector to the equipment to
operate.
• The clock blinks.
-_ Complete the initial setting again (_ page 30,
"INSTALLATION GUIDE").
• The clock does not keep time.
-_ Set the time and date manually (_ page 33,
"INSTALLATION GUIDE").
-_ Set "Summer time" or "Time zone" correctly
(_ page 34, "INSTALLATION GUIDE").
N
123