Manual

Programming the Remote Control
• This Remote Control is preprogranuned to operate TOSHIBA VCR's.
V '
• To use CR s other than TOSHIBA models (or cable coilvertel'), perfornl the following procedures before
operating.
POWER
®@
®
I
®i
I
i
!
J
!
I
I
TOSHIBA
RECALL
-- Number
Controlling other brands of VCR's and cable TV converters
] Ref'cr to the "VCR code table" (or "'Cable TV converter code
table") Oll pages 12 alld 13 to find the code IILIH3bcIINHI corresponds to
the brand IILIlllC el'your V(R (or con\ ellci ).
[tnlore thai1 t)llC IlUil/hel is listed, Ii} oath one s0paratcl} until you lind
the one thai \\ ork_,.
2 Set the TV/CABLE/VCR switch to "'V('R'" (o1 "'CABLE").
3 I lold down RECALL while pressing the Number buttons for tile three
digit code lc nbe" fo" yet r b and c t"VCR (€ r cc nvei_er)
4 Point the Remote Control tit the V('R (or tit Ille converter) and press
POWER to test the code number.
-If the right number ',','as entered, the \"CI'_ (or the con',erter) should
turn ofT.
IIfthe VCR (or the converter) does not respond to the Remote
Control, repeat steps I to 4 with another code number.
Reset tile TV/CABLENCR switch to '<TV'" to control the TV.
For I'uttlre reference, write down the code numbers yell used:
VCR CODE
CABLE CODE
Notes:
• Yo!I ]l(ll:(d to I'_/)Pogl'_lfl! I/l_: Relllo((." CoII!I'O/llh(_ll Felt (hallg(" it_ [)(IHL:/'ie,_.
• Soltw n¢lr_,vI'('R '_tu'_,_af)able o/workillg o_t_ith_,/'o/m.o r_,mnt_,_odes. The,se
IT'R _ hal'u a _ltitch/alwl_,d "I'(.NI/V('R2 ".
I/)'our I (-LRhm //li_ 4ind q/ slritdz, .ml *h_'._no! vu.vpomlm all the cod*, nuolhur,_
/br.l'om" lzCRhs'andname,,_t't t/w ,_lvllch re anoth_,r/_o._'ifiml(" VL'R] "'or "V('R2 "')
_111(/ I'(']H'O_._/'HIII 1[11 _ ]_UHIOt(' _'fHItI'O[
11