Manual

A ÷ L
Lampunit replacement and care
How to repJace the Jamp unit
z_ WAF{NING: RISK OFELECTRIC SHOCK!
TO REDUCE THE RiSK OF ELECTRICSHOCK, NEVER
REMOVE TV COVERS, EXCEPT AS SPEC|FJED
HEREIN, REFERALL SERViCiNG NOT SPECiFiED iN
THiS MANUAL TO QUALiFiED SERVICE PERSONNEL.
Failure to follow this WARNING may resuk Jndeath
or serious injul%
Required tools: Manua_ Philips screwdriver; g_o_as.
Opdona_ tad: 5/32" or 4ram AHen wrench.
1. Thin off'the TV and unphg d_e power cord,
.... WAR_I_: Eyedamage may result from
directly viewing the light pradaeed by this
, \,, tamp, Always turn off the TV and LInpfflgthe
power cord before opening the lamp unit door.
2. STOP! Allow the lamp to cool for at least one (I) hater
bd_re replacing it.
/
Touchingthe lamp before ithas cooled will resuRin
severe barns, ALLOW THE LAMP TO COOL FOR AT
LEAST ONE (1) HOUR BEFORE REPLACING IT.
3. Oil the Limp unit door oil the side of'd_e TV, bosen d_e
d_unlb screw by hand or by using a 5/32" or 4ram Allen
wrench, and then remove the hmp unit door.
TV back
Thumb
screw
Lamp unit door detail
4. Using a manual Philips screwdriver,_oosenthe rsvoscrewson
the hmp unit.
Lamp unit screws
WARNING: RISK OF
ELECTRIC SHOCK!
Thelampunit door isprovidedwith an ]
interlockto reducethe risk of electricshockand excessive
ultravioletradJatJm].Never defeat its purpose or attempt
to service without removingthe lamp unit door
completely. Failureto follow this WARNINGmayresult in
deathor seriousinjury.
5. Grasp the Iamp unit haildle and gendy pul the hmp mlit
smflght our of the _ Set the (lid hmp unh aside (see
"Disposirg of the used hmp unit" oil page 100).
Note: Wear gloves when
replacing the tamp unR.
÷
HM94(E}098-105(11-App)
99
Copyright © 2004 TOSHIBA CORPORATION, All rights reserved.
÷
8/31/04,12:00 PM
99
r