Manual

ManualsBrandsToshiba ManualstelevisionOfficial Toshiba dlp television

A ÷ [

Adjustingthe audio (co.ti..e¢

Using the SRS WOW TMsurround sound

WOW is a special combination of SRS Labs audio technologies

(SRS 3D, FOCUS, and TruBass) that creates a thrilIing

surround sound experience with deep, rich bassfl'om stereo

sound sources. Your TV's audio will sound fi41er,richer, and

wider.

To adiust the WOW settings:

1. Put theTV in STEREO mode (see "Selecting stereo/SAP

broadcasts" on page 79),

2. Press MENU and open the AUDIO menu.

3. HigNight ADVANCED AUDIO SETTINGS and press

ENTER.

)

4. Press Y or A to highlight the WOW fbature you want to

adjust, and then press 4 or _ to adjust the hem_

3D -- To turn the surround sound effbct on or of'£

Note: If thebroadcast/s rnonauf_l,tbe3D eftectdoesnot

wo_?

* Focus -- To turn the vocaI emphasis eff'ecton or off.

TruBass -- To select the desired bass expansion level

(HIGH, LOW, or OFF).

5. To temporarih_ save the new settings highlight DONE and

press ENTER. To permanentIy save the new settings,

highlight SAVE and press ENTER.

To reset the WOW settings:

Highlight RESET in the Advanced Audio Settings menu

and press ENTER.

SR.?WOWandthe (@) logoare tmdemad<sof SRSLabs,Inc

SRSWOWtechflo/ogy /s k_corpo_tedtinder/IbetTsefromSRSLabs,/no

Turning off the built=in speakers

Use this fbature to turn off the TV speakers when you connect

an audio system to your TV (see "Connecting a digital audio

system" and "Connecting an amflog audio system" on page 20).

To turn offthe bui]t4n speakers:

1. Press MENU and open the AUDIO menu.

2. Highlight AUDIO SETUP and press ENTER.

_a i{

.............................. _ _J _,, _j _,_, j

3. Press _' to highlight the SPEAKERS rid& and then

press _ to sdect OFE

4. To temporarily save the new se_tings,highlight DONE and

press ENTER. To permanentIy save the new settings,

highlight SAVE and press ENTER.

To turn on the built-in speakers:

Select ON in step 3 abo_e.

Selecting the optica a dio output

Use this _bature to select the opdcaI audio output t_._rmatwhen

you connect a Dolby Digital decoder or other digitaI audio

system to the OPTICAL AUDIO OUT jack on the TV (see

'%onnecting a digital audio system" on page 20)_

To select the optical audio output format:

1. Press MENU and open the AUDIO menu.

2. HigNight AUDIO SETUP and press ENTER.

3. Press _' to highlight the OPTICAL OUTPUT FORMAT

fidd, and then press _ to sdect either DOLBY DIGITAL

or PCM, depending on your device.

4. To temporarily save the new settings, highlight DONE and

press ENTER. To permanentIy save the new settings,

highlight SAVE and press ENTER.

HM94(E)O76-81(8b-UseTV) 81

8/31/04, 2:52 PM

[