Manual

A ÷ [

Connecting a digital audio system

The TV's DIGITAL AUDIO OUT jack outputs a

p[_ or>channe_dow>mi_edPCM(p<se<ode

meduhtion) signal fbr use with an external Dolby Digital

decoder or other external audio system with optical audio inpus.

You will need:

¢ one optical audio cable

To control the audio:

Tim1 on the TV and the digital audio device.

Press MENU on the TV's remote centre[ and open the AUDIO

lnentL

Highlight AUDIO SETUP and press ENTER.

hi the OPTICAL OUTPUT FORMAT rid& select either

DOLBY DIGITAL or PCM, depending <7,1your device (see

"Sdecting the optical audio output tbrmat" <3,1pate 81).

Turn off the TV's bulk-in speakers in the same AUDIO SETUP

menu (above). Also see '{Turning off the buih-in speakers" o,1

pate 8!.

DolbyDigitamflecofler or

Note:

* SomeaudiosystemsmaysTotbecompatiblewithDolbyD/_qitgJbii?__tle_m

S/qfl3f8 Older eL]clio SySl_tTIS fhc_[ 8re Rot compat/ia/e with SttJRdJtff_]

optics/out s/qf78f8<178ynot WOlRpmpedy, c/_afin51a h_lh slo/selevel fhat

frlay d;image speake/s of heao_phof?esTHIS DAMAGE IS NOT

COVERED BY YOUR WARRANTY

* 21eDIGITAL AUDIO OUI)iack may not output some d/d/t_l audio

surecos because of c'opy f_St/fet/of_&

The unauthorized recording, use, distribution, or revision of television

programs, videotapes, DVDs, and ether materials is prohibited under the

you to civil and criminal liability,

Connecting ananalogaudiosystem

This connection albws you to use external speakers with an Anam0gaudio stuNNer

externa[ attdio amp[ifier to adjust the sound [e_e[.

You will need:

one pair of standard audio cables

To control the audio: TV

Turn o,1 the TV and the stereo amplifier.

v,,,lo_theVV's_,_,_>_,1speakers(see"Wrn_,lgof_"the*,_tt-_,l

speakers" <>,1page 81).

Note: 7b hea_ sound w/?el_us/bg an external au&b amp//?te_

the volume of both the TVand the 8fglp/ff/ef must be set _) a

reasonabb //}ten/?ig bveZ

HM94(E)012 25(2B-Cnct)

20 _ 8/31/04, 12:53 PM [