Manual

Using the POP double-window feature
The POP (picture-out-picture) feature splits the screen into a double
window that allows you to watch two programs at the same time. The
POP program can come from a TV broadcast or an external source,
such as a VCR.
To display a TV broadcast in the POP window:
1. Press SPLIT to display the POP window.
Main
window
2. Select channels of the POP window in the following two ways:
• To change to a specific channels, press POP DIRECT CH.
While "POP" is on the screen, press the Channel Number
buttons (0-9 and 100).
• To change the next programmed channels, press POP CH
VA.
If the V-CHIP feature is active and you try to watch a TV
program that exceeds your set rating limits, the program will be
blocked (see "Using the V-CHIP menu" on page 39).
Note:
• YoucannogaccessPOP featureswhen
viewingDVI/npu_
• YoueannogdisplayanANT2signalsouree
in the POPwindow
• Youcan choose tooutput thesound of
either the main or POPprogram from the
AUDIO OUTjaeks (see "Selectingthe
Audio OUTsound" onpage 55) TheTV's
speakersa/waysou_outthe sound of the
main picture
-- Channel
(_ _ Number
_ -- EXIT
POP DIRECT CH
SPLIT
SOURCE
POPCHVA
To display a picture from an external source in the POP window:
1. Connect the external source equipment (see "Connecting your
TV" on page 8).
2. Select the TV program you want to watch in the main window.
3. Press SPLIT to display the POP window.
4. Repeatedly press SOURCE to select the input source for the POP
window (VIDEO 1, VIDEO 2, VIDEO 3, ColorStream HD1,
or ColorStream HD2 only; you cannot select DV1 in POP
mode). The current source will display in purple.
5. You can play a tape as the POP picture, or select a channel for the
POP window using the VCR's channel keys.
NOTICE OF POSSIBLE ADVERSE
EFFECTS ON TV PICTURE TUBE
Avoid displayingstationary imageson
your TV screenfor extended periodsof
time. Fixed (non-moving) images (such
as still PIP/POPwindows or blacWgray
bars in wide-screen picture or PIP/POP
formats) can become permanently
engrained in the picturetube. This type
of damage is NOT COVERED BY
YOUR WARRANTY beeauseitisthe
result of misuse.Seeitem 33 on page 4.
34
While the above menu is on the screen, you can select the desired
signal input source by pressing the corresponding number button
(0-5).
To close the POP window:
Press SPLIT again or EXIT.