Manual

Manually adjusting the color convergence
1. Press MENU, and then press • or • until the PICTURE menu
appears.
2. Press • or • to highlight CONVERGENCE (below left).
3. Press • or • to display the Center Convergence menu (below
right).
P_CTURE ANTENNA
_ODE SPORTS
FLESH TONE ON
CableC_ear DNR OFF
COLOR
TEMPERATURE COOL
__DISPLAY F RMAT 108Oi
-4-
Ill. BLUE
_TO ADJUST
ENTER :TO SELECT COLOR
E×IT _TO SELECT POSITION
.
5.
If you see separate red, blue, or green crossed lines (or red or blue
shadows next to white lines), you need to adjust the convergence.
Press ENTER to highlight RED or BLUE, depending on which
color needs adjusting. If both red and blue need adiusting, you
will need to perform steps 4 and 5 twice.
Press • (up), • (down), • (left), or • (right) on the remote
control to converge the red or blue line into the green line, which
will turn completely white when correctly adiusted. When color
convergence is correctly adiusted, you will see two single crossed
white lines.
6. Press EXIT to display the Circumference Convergence menu.
7. Press the corresponding Number button (1-4 and 6-9) to select
the area you want to adjust.
8. Press ENTER to highlight RED or BLUE, depending on which
color needs adjusting. If both red and blue need adiusting, you
will need to perform steps 8 and 9 twice for the selected area.
-4-
RE_mmm
_TO ADJUST
ENTER :TO SELECT COLOR
E×IT _TO SELECT POSITION
9. Press ••• • to converge the red or blue line into the green line,
which will turn completely white when correctly adiusted. Repeat
steps 8 and 9 until you see two single crossed white lines.
10. Press EXIT once to select another area to adjust, and then repeat
steps 7-9.
11. Press EXIT twice to close the Convergence menu.