Manual

Adding channels to the TV's memory
When you press Channel • or •, your TV will stop only on the
channels stored in the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels (see page 24).
To program channds automatically:
1. Press MENU, and then press • or • until the SET UP menu
appears.
2. Press • or • until the TV/CABLE is highlighted.
3. Press • or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TVi if you use
cable, highlight CABLE.
SET UP
LANGOAGE ENGLISH
CLOCK SET OO_OO
CH PROGRAM _ •
ADD/ERASE ADD
QO]CK CONNECT GO,DE
4. Press • to select CH PROGRAM.
Note."
Totune the TVto a channel nog programmed
/rzthe channel memo_ you must use the
Channel Number buttons on the remote
contrb[
i®0¸¸®¸¸
® ® ®
® ® ®
do®
MENU
&V_ •
Channel .&V
SET UP
LANGOAGE ENGLISH
CLOCK SET 00_00
ANTI/2 ANTI
QO]CK CONNECT G0_DE •
5. Press • or • to start channd programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channds, the message
"Programming Now--Please Wait" appears.
6. When channel programming is complete, the message
"Completed" appears.
7. Press Channel • or • to view the programmed channds.
Adding and erasing channels manually
After you have programmed tile channels automatically, you can
manually add or erase specific channds.
To add or erase channels:
1. Select the channel you want to add or erase. If you are adding a
channel, you must select the channel using the Channel Number
buttons.
2. Press MENU, and then press • or • until tile SET UP menu
appears.
(eont/bued on nextpage)
23