Manual

To control the audio, turn on the TV and the stereo amplifier, and
turn off the built-in speakers (see "Turning off the built-in speakers"
on page 55).
You will need:
• one pair of audio cables
Note:
Tohear sound when usingan externalaudio amphfier,the
volumeof both the TVand the amplifier must be set
above0 Czero)
For example,ff the volume of the TVisset to O,you will
not be able to hear anysound, even the volume of the
amplifier isat itshighest level
Connecting an A/V receiver
This connection allows you to use an audio/video (A/V) receiver to
enhance your TV's sound.
If you have a system with Dolby Pro Logicc#surround sound, you can
add to the realism of the sound by using the TV's internal speakers as
center channel speakers.
You will need:
• onesetofA/V cables
• one single audio cable for the audio center channel
!
From
Video OUT
TV
To A/V Receiver
I
t
From
To TV IN Center OUT
[_ OFF
Note:
Refer to the instructionsprovided w/d?your A/V receiver
for detailsaboutyour surround soundsystem
WhentheAu&o Center ChannelON/OFF sw/tehism
the ONposition, the TVspeakerswill fund/on only as
center ehannelspeakers At this tffne, the SBS feature
should be set OFf7Seepage 54
Adjust the volumefor the center channelspeakers
using the center level control on theA/V receiver
Touse the TVspeakersas normal speakers,set the
Au&o CenterChannelON/OFFswitch to the OFF
pos/don
TV
Caution:
Toavoid damaging the TVspeakers:
• Turnoff the TVbefore connecting or
discenneeOngthe Au&o Center Channel
cable
• DonogeonnectfmmtheA/Vreeeiver's
Center SpeakerOUT Campl/f/edsignal) to
the TV'sAu&o Center ChannelIN
Dolby Pro Logic* surround sound
system connection example
__Audio Video
eft Right
peaker speakel
Surround SurtouRd
speakerL 6 speakerR
* Dolby Pro Logic isa registered trademark
of Dolby Laboratories Licensing
Corporation.
15