Manual

Verifying the device code {990)
Use this feature to yetiS, the codes for your other devices. The
number of blinks after pressing the 1,2, 3, and 4 buttons is the
4 digit code set up for that mode.
Example: To veri_ the VCR code is 0385:
1. Press MODE to select the VCR mode.
2. While holding down the RECALL button, press 9, 9, 0 in
sequence.
3. Press 1 _ 0 blinks.
4. Press 2 _ 3 blinks.
5. Press 3 _ 8 blinks.
6. Press 4 _ 5 blinks.
You can veri_ Tthat the device code of the VCR mode is "0385."
Using the Volume Lock feature {993)
For the TV, CABLE/SAT, VCR, and DVD modes, the volume
controls (VOL AV and MUTE) can be programmed or locked to the
selected device mode. This feature does not apply m the AUDIOI/2
modes.
Example: To lock the volume controls m always jump to the CABLE/
SAT mode:
1. Press MODE to select the CABLE/SAT mode.
2. While holding down the RECALL button, press 9, 9, 3 in
sequence.
3. Press VOL A. The Mode indicator will blink two times (locked).
Number
@@1
"-- NODE
C2£
The following table describes in more detail the _lume Lock
implementation.
TV CBL/SAT VCR L)VD AUD] AUD2
TV TV TV TV AUD1 AUD2
CBL/SAT CBL/SAT CBL/SAT CBL/SAT AUD1 AUD2
VCR VCR VCR VCR AUDI AUD2
DVD DVD DVD DVD AUD] AUD2
AUDI AUD] AUDI AUD] AUDI AUDI
U][7) £ AUD2 AUD2 AUD2 AUD2 AUD2 AUD2
To reset the volume controls to the original device code:
1. Pressing the RECALL button, press 9, 9, 3 in sequence.
2. Press VOL V. The Mode indicator will blink four times
(unlocked).
Operational feature Reset {980)
This feature clears all setup features not related to "Device code set
tip" and resets the Volume Lock to "TV."
To reset the features:
While holding down the RECALL button, press 9, 8, 0 in order.
The Mode indicator will blink two times, then pause and blink
two more times,
15