Operation Manual

43
CONTROLS AND FEATURES
English
Setting up the Network
You can select the Network Type.
a Press MENU / C c to highlight Setup icon.
b Press B / C c to highlight Preferences icon and
press OK.
c Press B or b to select Network Setup and press OK.
d Press B or b to select Network Type and press C or
c to select Wired or Wireless.
NOTE: For SL863 series, if the Dual Band WLAN
Adaptor is not connected, Wireless cannot be
selected.
e If you selected Wired, see “Advanced Network Setup”
on page 45.
NOTE (for SL86 series):
• This feature is grayed out when the Dual Band WLAN
Adaptor is not connected or Network Type is set to Wired.
• When you insert or remove the wireless LAN adaptor, you
must turn off your TV and unplug the power cord, and then
plug and turn on again.
• Continued connection of AP (Access Point) is not guaranteed.
The connection may be disconnected while watching TV.
• Do not remove the Dual Band WLAN Adaptor when
Network Type is set to Wireless or wireless
communication is active.
There are 3 methods for Wireless Setup:
Easy Setup (WPS)
If the AP supports WPS, this method can be used.
• WPS is an industry standard designed to make connection
of wireless LAN equipment and security setup easy. WPS
will automatically configure all wireless settings.
NOTE: WEP encryption may not be able to be configured by
easy setup.
Assisted Setup (setup by using the AP’s notification
information)
Network Name, Authentication, and Encryption are decided
based on information from the AP. You will manually set the
Security Key.
Manual Setup (manual input of all settings)
Easy Setup using PBC (Push Button Configuration)
a In the Preferences menu, press B or b to select
Network Setup and press OK.
b Press B or b to select Wireless Setup and press OK.
c Press B or b to select Easy Setup and press OK.
d Press C or c to select PBC.
e Press b to highlight Start Scan and press OK.
f Following the on-screen instructions, push the
appropriate button on your AP.
g When a window reporting that the setup is complete
appears, press OK.
To cancel searching for the AP:
Press BACK while searching for the AP. A message will
appear and press C or c to select Yes and press
OK.
Easy Setup using PIN (Personal Identification
Number)
a In the Preferences menu, press B or b to select
Network Setup and press OK.
b Press B or b to select Wireless Setup and press OK.
c Press B or b to select Easy Setup and press OK.
d Press C or c to select PIN.
e Press b to select Start Scan and press OK.
f Press B or b to select the desired AP and press OK.
NOTE: Check the Network Name and/or MAC address
on the label of the AP or in the manual, and select
your AP.
g When the PIN code window appears, enter the
displayed PIN into your AP and press Next to continue
the PIN Setup. When a message displays to report that
the setup is complete, press OK.
Wireless Setup
Preferences
Personal TV Setup
REGZA-LINK Setup
Recording Setup
Photo Frame Setup
Network Setup
Camera Sensor Setup
Network Device Setup
Teletext Auto
Network Type Wired
Network Connection Test
Advanced Network Setup
Network Setup
Wireless Setup
Easy Setup On
Enhanced 11n Off
Manual Setup
Wireless Setup
Assisted Setup