Manual

initial Setup
When you first turn on or reset the TV. the Initial
Setup window will appear.
1 [)1the Menu Languagefield, press 4 or _ to
select your preferred language.
2 Press 4 or _ to select Time Zone and set your
desired time zone with 4 or _ and press @.
3 Next, the Location setting window will appear.For
normal home use, press 4 or _ to select N0me
and press @.
4. Next, ANT/CABLEIn setup window will appear.
Press _llor _ to select the input source (Cable or
Antenna) for the ANT/CABLEinput on the TV.
5 [f you select Antenna,the ChannelTuningNode
setup window will appear. To tune only digital
channels, select DigitaJ. To tune digital channels
preferentially over analog when entering channel
number directly, select Ant0. For normal tuning,
selectStandard.Press @_ to continue to Auto
Tuning.
6 Press @ to select Start Scan and continue with
the Auto Tuning.
• EXIT
You can stop the Initial Setup with O •However if
you do not finish the entire Initial Setup process, the
Initial Setup window will appear every time you turn
on the TV.
Selecting the menulanguage
You can choose from three different languages
(English, French and Spanish) for the on-screen
display of menus and messages.
To select the menu language:
MENU
Press © and open the Preferences menu,
highlight Menu Language.
Press "9 or _ to select your preferred menu
language.
EXIT
Press © to close the Preferences menu.
24
Configuring the antenna input
source for the ANT/CABLEterminal
To configure the ANT/CABLE input source:
MENU
1 Press O and open the Setup menu.
Highlight Installationand press @.
3 (A new set of JnstaJJationmenu icons will appear,
as shown below.) Open the Terrestrialmenu,
highlight Inpnt Configuration,and press @.
Highlight ANT/CABLEin and press 41 or _" to
select the input source (Cableor Antenna)for the
ANT/CABLEinput on the TV.
5 Tosave your new settings, highlight [}oneand press
EN@.To revert to your original settings, highlight
CanceJ and press @_.
Programmingchannelsinto the
TV's channelmemory
When you press [_ or _ on the remote control
or TV control panel, your TV will stop only on the
channels you programmed into the TV's channel
memory.
Follow the steps below to program channels into the
TV's channel memory.
Programming channelsautematicaiJy
Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory. (conHnued)