Operation Manual

22
Manual TV station presetting (continued)
• *When Ant/Cable In is set to Cable, the following information will be displayed:
- Frequency(kHz): A specific frequency can be input for scanning.
- Symbol Rate: A specific baud rate (KS/s) can be input for manual scanning.
- Modulation: Select from five QAM modulation options
After setting the channel, press ENTER/CH LIST to start scanning for channels.
Note:
• This setting cannot be enabled due to DVB-C unavailability. Please check if this function is
supported in the place you live, and if the latest firmware has been installed on your TV (see
DVB-C Notice on page 2 and DVB-C function notice on page 12).
5 Press EXIT/CANCEL to return to the normal screen.
[0-9] : Select
Manual Tuning
Frequency(kHz) 113000
Symbol Rate 6900
Modulation 64 QAM
DTV Channel Found 5
Radio Channel Found
3
Manual Tuning
Completed
Frequency(kHz) 113000
Symbol Rate 6900
Modulation 64 QAM
EXIT : Cancel