User's Manual
Table Of Contents
- PRECAUTIONS
- Precautions for Use
- About TOSHIBA Wireless Solution
- Wireless Interoperability
- Wireless LAN and your Health
- Safety Instruction for Wireless Products
- Regulatory Information
- Canada - Industry Canada (IC)
- Europe - EU Declaration of Conformity
- USA-Federal Communications Commission (FCC)
- Regulatory Notice for Channel Use in France
- Approved Countries/Regions for use for the Toshiba Wireless LAN
- NOTES!
- Table of Contents
- Setting Up Wireless Network
- Appendix
- INDEX
1. Setting Up Wireless Network
GN-1050 Operator’s Manual — Setting up the Ad Hoc Mode 41
z [WEP KEY]
Press this to enter the WEP key.
The maximum length of WEP key varies depending on the WEP Encryption and
Key Entry Method.
SUPPLEMENT: When pressing the [WEP KEY button, the letter entry screen is displayed. Enter the
value using the keyboard and digital keys, and press the [ENTER] button to set the
entry.
3. Select the transmit power and press the [NEXT] button.
• Select the low transmit power if you want to limit the area that the wireless
communication is enabled. If you do not have to limit the area, select
[100%].
4. Confirm the settings and press the [FINISH] button.
• The shut down screen is displayed.
SUPPLEMENT: If you want to change the settings, press the [PREV] button to move back to the screen
that you want to change and then repeat the operation.
64bit 128bit 152bit
HEX :
10 26 32
ASCII :
51316