User's Manual
Table Of Contents
- PRECAUTIONS
- Precautions for Use
- About TOSHIBA Wireless Solution
- Wireless Interoperability
- Wireless LAN and your Health
- Safety Instruction for Wireless Products
- Regulatory Information
- Canada - Industry Canada (IC)
- Europe - EU Declaration of Conformity
- USA-Federal Communications Commission (FCC)
- Regulatory Notice for Channel Use in France
- Approved Countries/Regions for use for the Toshiba Wireless LAN
- NOTES!
- Table of Contents
- Setting Up Wireless Network
- Appendix
- INDEX
1. Setting Up Wireless Network
28 GN-1050 Operator’s Manual — Setting Up the Infrastructure Mode
z TRANSMIT RATE
Select the transmit data capacity for wireless communication. If you do not have
to specify the fixed rate, select [AUTO]. When [AUTO] is selected, this
equipment will use appropriate rate depending on the condition.
Generally select [AUTO]. The communication may fail unexpectedly if you
select a static transmit rate.
8. Confirm the settings and press the [FINISH] button.
• The shut down screen is displayed.
SUPPLEMENT: If you want to change the settings, press the [PREV] button to move back to the screen
that you want to change and then repeat the operation.
9. Press the [YES] button to shut down the equipment.
• The wireless settings apply after restarting the equipment.
Selecting WPAPSK/WPA2PSK security mode
The WPAPSK/WPA2PSK is an authentication method using the PSK (Pre-Shared Key)
between the Access Point and other wireless devices.
To access the wireless network using the WPAPSK/WPA2PSK authentication, the
same PSK Path Phrase must be assigned in both the Access Point and other wireless
devices. If the PSKs are same between the Access Point and other wireless devices,
the Access Point allows them to access the wireless network through the Access Point.