User's Manual

1. Setting Up Wireless Network
26 GN-1050 Operator’s Manual — Setting Up the Infrastructure Mode
z [RETYPE PASS]
Press this to enter the EAP password again that you enter in the EAP
PASSWORD field.
SUPPLEMENT: When pressing each button, the letter entry screen is displayed. Enter the value using
the keyboard and digital keys, and press the [ENTER] button to set the entry.
4. Specify the following items and press the [NEXT] button.
z ENCODING FORMAT
Select the encoding format of the CA certification file.
z [CA CERTIFICATE]
Press this to enter the file name of the CA certification file that you install in the
equipment using TopAccess. If the specified certification file is not installed in
the equipment, the error message to input correct file name will be displayed.
SUPPLEMENT: When pressing the [CA CERTIFICATE], the letter entry screen is displayed. Enter the
value using the keyboard and digital keys, and press the [ENTER] button to set the
entry.
5. Specify the following items and press the [NEXT] button.
z FULL AGREEMENT of SERVER NAME
Select the [ON] button to confirm whether the RAIUS server name in the server
certification file and the input RADIUS server name is same or not. When the
[ON] button is selected, press the [RADIUS SERVER NAME] button to enter the
RADIUS server name.
NOTE: In the RADIUS SERVER NAME, enter the user name in “Server Name@FQDN” format.
Example: [e-mail]
z ENCRYPTION INTENSITY
Select the encryption intensity. When the PEAP protocol is selected, only [LOW]
can be selected.