User's Manual

3PrinterOper ationResettingYourPrinter
20
3.2.2 DumpMode
TheprinterwillentertheDumpmodeafterrunningaselftest.Inthismode,
charactersareprintedinhexadecimalcodes,allowingusersandengineers to
debugthesystem.
Toreturntotheonlinemode:
￭ Turnofftheprinter,andturnitonagain.

3.3 Resett ingYourPrinter
Byresettingyourprinter,youcanreturnyourprintertothestateitwasin
whenyoureceiveit.Thiscanhelpyousolvesomeproblemscausedby
settingschangedduringtheprinting.

Dothefollowingtoresetyourprinter:
1. Turnofftheprinter.
2. PressandholdtheFEEDbutton,andturnontheprinter.
3. Bothstatuslightsglowsolidorangeforafewseconds.Next,theyturnto
greenshortly,andthenturntoothercolors.Whenbothlightsturnto
red,releasetheFEEDbuttonimmediately.
4. PressandholdtheFEEDbuttonfor3seconds
andreleaseit.Bothstatus
lightsblinkredthreetimes,andturntosolidorangeforafewseconds.
Aftertheprinterisreset,LED2goesoutwhileLED1turnstosolidgreen.


ImportantInstep4,ifyoudonotholdtheFEEDbuttonlongenough,
LED2willblinkorangethreetimeswhileLED1goesout.Itmeansthe
printerisnotreset.