User's Manual

2GettingStarted AttachingPower
8
2 GettingStarted
Thischapterdescribeshowtosetupyourprinter.
2.1 At tachingPower
1. MakesurethepowerswitchissettotheOFFposition.
2. Insertthepowersupply’sconnectorintotheprinterpowerjack.
3. InserttheACpowercordintothepowersupply.
4. PlugtheotherendoftheACpowercordintothewallsocket.
ImportantUseonlypowersupplieslistedintheuserinstructions.




WarningDonotplugtheACpowercordwithwethands,oroperatethe
printerandthepowersupplyinanareawheretheymaygetwet.Serious
injurymayresultfromtheseactions!