User's Manual

1Introduction PrinterLights
7
1.4.2 SystemMode
Thesystemmodeconsistsofstatuslightcolorcombinations.Itcontainsalist
ofcommandsforyoutoselectandrun.

Toenterthesystemmodeandrunthecommand,dothefollowing:
1. Turnofftheprinter.
2. PressandholdtheFEEDbutton,andturnontheprinter.
3. Bothstatuslightsglowsolidorangeforafewseconds.Next,theyturnto
greenshortly,andthenturntoothercolors.
4. Whenstatuslightsshowthecolorcombinationyouneed,releasethe
FEEDbuttonimmediately.
5. PresstheFEEDbuttontorunthecommand.

Thefollowingtableisthecommandlistofthesystemmode.
LED1 LED2 Command
Green Red TransmissiveSensorCalibration(Section3.1)
Green Orange ReflectiveSensorCalibration(Section3.1)
Red Red ResettingthePrinter(Section3.3)
Red Orange TPCLAutoCallCancellation
Red Green DisableCheckingRTCBatteryCharge
Orange Red DisableBASICMode
Orange Green SelfTestandDumpMode(Section3.2)


NoteForinformationaboutTPCLAutoCallandBASICMode,please
refertoB‐FV4Dtechnicalmanual.