User's Manual

8/12
Copyright© 2014 TOSHIBA Corporation – Semiconductor & Storage Products Company
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment has been SAR-evaluated for use in hand.
SAR measurements are based on a 5mm spacing from the body and that compliance is achieved at that distance.
Canadian Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
The following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
This device complies with the Canadian ICES-003 Class B specifications and RSS-210 of Industry Canada.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations. Wireless operation is subject to 2 conditions. The first is that the wireless device may not
cause interference. The second is that the wireless device must accept any interference, including
interference that may cause undesired operation of the device.
To comply with the Canadian RF exposure compliance requirements, this device and its antenna
must not be co-located or operating in conjunction with any other antenna or transmitter.
Avis Canadien
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Cet appareil est conforme à la norme canadienne NMB-003 classe B et CNR-210 d'Industrie Canada.
Ce dispositif numérique de classe B respecte toutes les exigences du Règlement canadien matériel brouilleur.
Fonctionnement sans fil est soumis à deux conditions. La première est que l'appareil sans fil peut ne pas
provoquer des interférences. La seconde est que le dispositif sans fil doit accepter toute interférence,
y compris les interférences qui peuvent causer un mauvais fonctionnement de l'appareil.
Pour se conformer aux exigences de conformité RF canadienne l'exposition, cet appareil et son antenne
ne doivent pas être co-localisés ou fonctionnant en conjonction avec une autre antenne ou transmetteur.
European Union Regulatory Notice
This device bearing the CE marking is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. This device
complies with the following harmonized European standards.
Safety: EN62479:2010
EMC : EN301489-1V1.9.2:2011,EN301489-17V2.2.1:2012
EN 55022 : 2010/AC:2011,EN 55024 : 2010 IEC 61000-4-2 : 2008,IEC 61000-4-3 :
2006+A1:2007+A2:2010 IEC 61000-4-8 : 2009
Radio: EN300 328 V1.8.1:2012
● The following CE marking is valid for EU harmonized telecommunications products.
Refer to the regulatory label provided on this product.
EU Declaration of Conformity: This Product carries the CE-Mark in accordance with the related European Directives.
Toshiba Electronics Europe GmbH, Hansaallee 181, D-40549 Dusseldorf, Germany is responsible for CE-Marking.
0560