User's Manual

Chapter 3: Configuring the Access Point via Web Browser

Setting up a Host PC

To configure the Access Point via web browser, at least one properly-configured PC must be

connected to the network (either connected directly or through an external hub to the LAN port

of the device). The host PC must meet the following requirements:

l With Ethernet network interface.

l Must have TCP/IP installed.

l With a web browser installed: Internet Explorer 5.x or later.

For Ethernet interface: With Ethernet network interface card installed.

For WLAN client: LAN card driver installed. The SSID setting will be the last 6 codes of the

MAC address of your Access Point.

Using Web Configuration

Once your host PC is properly configured, start the web browser and type the URL 192.168.1.20

to enter the Web configuration page.

You will be prompted to enter username and password. By default, the username is admin and

password is password.

Note:

The Access Point uses the

Apply

button to enable new settings. When

Apply

button is

clicked, your customizations will be stored to the Access Point.