User's Manual

8-11
OO
OO
O
PTIONALPTIONAL
PTIONALPTIONAL
PTIONAL
D D
D D
D
EVICESEVICES
EVICESEVICES
EVICES
NOTE: Use a 0-bit, Phillips screwdriver to remove and fasten screws. Use
of an incorrect screwdriver can damage the screw heads.
Removing and installing memory module in
Slot A
Follow the steps below to remove and install a memory module in Slot A.
1. RTurn the computer’s power off. Make sure the Power indicator is off.
2. Remove AC adaptor and all cables connected to the computer.
3. Turn the computer upside down with the front side of the computer facing to
you and remove the battery pack. Refer to Removing the Battery Pack in
chapter 6; Power and Power-up Modes for the detail.
4. Turn the computer to the normal position and open the display panel. Remove
the keyboard brace. Use thin flat blade driver to remove the brace.
K EYBOARD BRACE
Figure 8-9 Removing the keyboard brace
Memory expansion