User's Manual

7-7

HW SHW S

HW S

ETUPETUP

ETUP

ANDAND

AND

ASSWORDSASSWORDS

ASSWORDS

HW Setup

This procedure does not affect the settings.

❑ Use hot keys.

1. Hold down F12 and boot the computer.

2. The following menu will be displayed with the following icons: Built-in HDD,

CD-ROM, FDD, Network (LAN), PCA (ATA) card boot.

NOTE: A bar will appear only under the selected device.

3. Use the left/right cursor keys to highlight the boot device you want and press

Enter.

NOTES: 1. If a supervisor password is set, the menu above does not

appear when you use the user password to start the

computer.

2. The selection method above does not change the boot

priority settings in HW Setup.

3. If you press a key other than one of those above or if the

selected device is not installed, the system will boot according

to the current setting in HW Setup.

Network Boot Protocol

This feature sets the protocol to remotely boot from the network.

[PXE] Sets PXE as the protocol. (Default)

[RPL] Sets RPL as the protocol.

NOTES: 1. PC card HDD boot is supported only by the PC card slot

on the computer. Support is guaranteed only for TOSHIBA

PC card HDDs.