User's Manual
Table Of Contents
- User誷 Manual
- Content
- Conventions
- Abbreviations
- Icons
- Safety icons
- Safety Instructions
- Do not disassemble, modify, tamper with or repair your product
- Handling the AC adaptor and power cables/cords or plugs
- Attaching the power cable/cord
- Dust on the power plug connectors or connector base
- Only use TOSHIBA AC adaptor
- Use correct power source
- Do not handle the power plug with wet hands
- Choking hazards
- Avoid liquids, moisture and foreign objects
- Never place your product or AC adaptor on a heat sensitive surface
- Never place your product in locations with excess heat
- Never place your product in a location with extremely low temperatures
- Never subject your product to sudden temperature variations
- Never operate your product during a thunderstorm
- Regulatory Statements
- Copyright Statement
- Disclaimer
- Trademarks
- TOSHIBA Support
- Precautions for Microsoft® Windows® 7 and Windows 8.1
- Introduction
- Quick Tour
- Using your dynadock for the first time
- Configuring Audio Ports
- Configuring Video Ports
- How Standby/Sleep/Hibernation Mode Affects Devices Attached to the dynadock
- Using the AP (Access Point) function
- Troubleshooting
- Specification
EN-8 User’s Manual
dynadock
TM
WiAC
CE Compliance
Working Environment
This product was designed to fulfil the EMC (Electromagnetic Compatibility)
requirements to be observed for so-called “Residential, commercial and
light industry environments”. TOSHIBA do not approve the use of this
product in working environments other than the above mentioned
“Residential, commercial and light industry environments”.
For example, the following environments are not approved:
■ Industrial Environments (e.g. environments where a mains voltage of
380 V three-phase is used)
■ Medical Environments
■ Automotive Environments
■ Aircraft Environments
Any consequences resulting from the use of this product in working
environments that are not approved are not the responsibility of TOSHIBA.
The consequences of the use of this product in non-approved working
environments may be:
■ Interference with other devices or machines in the near surrounding
area.
■ Malfunction of, or data loss from, this product caused by disturbances
generated by other devices or machines in the near surrounding area.
Therefore TOSHIBA strongly recommend that the electromagnetic
compatibility of this product should be suitably tested in all non-approved
working environments before use. In the case of automobiles or aircraft, the
manufacturer or airline respectively should be asked for permission before
use of this product.
Furthermore, for general safety reasons, the use of this product in
environments with explosive atmospheres is not permitted.
REACH
Following information is only valid for EU-member States:
REACH - Compliance Statement
The European Union (EU) chemical regulation, REACH (Registration,
Evaluation, Authorization and Restriction of Chemicals), entered into force
on 1 June 2007, with phased deadlines to 2018.
This product is CE marked in accordance with the
requirements of the applicable EU Directives. Responsible
for CE marking is TOSHIBA EUROPE GMBH,
Hammfelddamm 8, 41460 Neuss, Germany. A copy of the
official Declaration of Conformity can be obtained from
following website: http://epps.toshiba-teg.com.