User's Manual
Table Of Contents
- User誷 Manual
- Content
- Conventions
- Abbreviations
- Icons
- Safety icons
- Safety Instructions
- Do not disassemble, modify, tamper with or repair your product
- Handling the AC adaptor and power cables/cords or plugs
- Attaching the power cable/cord
- Dust on the power plug connectors or connector base
- Only use TOSHIBA AC adaptor
- Use correct power source
- Do not handle the power plug with wet hands
- Choking hazards
- Avoid liquids, moisture and foreign objects
- Never place your product or AC adaptor on a heat sensitive surface
- Never place your product in locations with excess heat
- Never place your product in a location with extremely low temperatures
- Never subject your product to sudden temperature variations
- Never operate your product during a thunderstorm
- Regulatory Statements
- Copyright Statement
- Disclaimer
- Trademarks
- TOSHIBA Support
- Precautions for Microsoft® Windows® 7 and Windows 8.1
- Introduction
- Quick Tour
- Using your dynadock for the first time
- Configuring Audio Ports
- Configuring Video Ports
- How Standby/Sleep/Hibernation Mode Affects Devices Attached to the dynadock
- Using the AP (Access Point) function
- Troubleshooting
- Specification
EN-30 User’s Manual
dynadock
TM
WiAC
WPS function
While being used as an AP, the WPS button allows you to connect to the
Internet without a password.
1. Click the Internet icon in the Notification Area of your Windows
®
desktop
and connect to “dynadockWiAC_xxxxxx”.
2. Press the WPS button for about 5 seconds and the connection is
completed.
Troubleshooting
WPS function can be used for only one user at a time.
Problem Procedure
AC adaptor does not
power the dynadock.
Check the connections to make sure that the power
cord/adaptor is firmly connected to the dynadock
and a working power outlet.
Check the condition of the cord and terminals. If the
cord is frayed or damaged it should be replaced,
while if the terminals are soiled, they should be
cleaned with a clean cotton cloth.
If the AC adaptor still does not power the dynadock,
you should contact TOSHIBA Support.
No video on the
monitors attached to
the HDMI port or the
DisplayPort on the
dynadock.
Make sure the computer is connected with the
dynadock.
Make sure that the video cable is tightly secured to
the video port in the dynadock and that the display
output setting of the monitor is set to the correct
mode.
This might be due to the monitor(s) supporting
higher resolutions than the dynadock is able to
support. Check the Configuring Video Ports section
in this manual for details.
If only one monitor is shown, while the other is not,
go to the Intel Graphics Control Panel to select the
output for the second monitor.
If three displays are plugged into the dynadock, only
a maximum of two external monitors are supported.