User's Manual
Table Of Contents
- User誷 Manual
- Content
- Conventions
- Abbreviations
- Icons
- Safety icons
- Safety Instructions
- Do not disassemble, modify, tamper with or repair your product
- Handling the AC adaptor and power cables/cords or plugs
- Attaching the power cable/cord
- Dust on the power plug connectors or connector base
- Only use TOSHIBA AC adaptor
- Use correct power source
- Do not handle the power plug with wet hands
- Choking hazards
- Avoid liquids, moisture and foreign objects
- Never place your product or AC adaptor on a heat sensitive surface
- Never place your product in locations with excess heat
- Never place your product in a location with extremely low temperatures
- Never subject your product to sudden temperature variations
- Never operate your product during a thunderstorm
- Regulatory Statements
- Copyright Statement
- Disclaimer
- Trademarks
- TOSHIBA Support
- Precautions for Microsoft® Windows® 7 and Windows 8.1
- Introduction
- Quick Tour
- Using your dynadock for the first time
- Configuring Audio Ports
- Configuring Video Ports
- How Standby/Sleep/Hibernation Mode Affects Devices Attached to the dynadock
- Using the AP (Access Point) function
- Troubleshooting
- Specification
User’s Manual EN-29
dynadock
TM
WiAC
How to go to the Web Graphical User Interface
Follow these instructions to enter the web Graphical User Interface.
1. Click the UDS icon in the Notification Area of your Windows
®
desktop
and select “dynadock WiAC Configure Setting”.
Or, open your web browser, type in IP address http://192.168.1.1 in the
address field and press Enter.
2. Enter Username and Password. Both of them are “admin” by default.
3. Click OK to continue.
After a successful login, you can configure and manage the dynadock.
Options in the Web Graphical User Interface
Web Graphical User Interface provides the following information and
configuration options.
■ Wizard Setup Home (by default)
■ Advanced Setup Home (by clicking on the upper-right corner on the
page)
WAN Setup
Wizard
Allows you to set up Internet or WAN connection.
WiFi Setup
Wizard
Allows you to set up WiFi, including change the SSID
(the name of the dynadock to be shown in the Network)
Status Allows to view the current status and configuration.
Basic Allows you to change the Username and Password.
LAN Shows the IP address: 192.168.1.1 (by default)
Radio Allows you to configure for WiFi Channels and
Bandwidth.
SSID Allows you to change the SSID (the name of the
dynadock to be shown in the Network)
Security Allows you to configure the security settings for WPA2.
Firmware Allows you to view the current firmware version and
upgrade it if necessary.
Status Allows to view the current status and configuration.