User's Manual
Table Of Contents
- User誷 Manual
- Content
- Conventions
- Abbreviations
- Icons
- Safety icons
- Safety Instructions
- Do not disassemble, modify, tamper with or repair your product
- Handling the AC adaptor and power cables/cords or plugs
- Attaching the power cable/cord
- Dust on the power plug connectors or connector base
- Only use TOSHIBA AC adaptor
- Use correct power source
- Do not handle the power plug with wet hands
- Choking hazards
- Avoid liquids, moisture and foreign objects
- Never place your product or AC adaptor on a heat sensitive surface
- Never place your product in locations with excess heat
- Never place your product in a location with extremely low temperatures
- Never subject your product to sudden temperature variations
- Never operate your product during a thunderstorm
- Regulatory Statements
- Copyright Statement
- Disclaimer
- Trademarks
- TOSHIBA Support
- Precautions for Microsoft® Windows® 7 and Windows 8.1
- Introduction
- Quick Tour
- Using your dynadock for the first time
- Configuring Audio Ports
- Configuring Video Ports
- How Standby/Sleep/Hibernation Mode Affects Devices Attached to the dynadock
- Using the AP (Access Point) function
- Troubleshooting
- Specification
User’s Manual EN-23
dynadock
TM
WiAC
Configuring audio recording ports (Microphone)
1. Right-click the speaker icon in the Notification Area of your Windows
®
desktop.
2. Select Recording Devices from the menu.
3. On the Recording tab of the dialog box, select one of the following:
■ A Realtek High Definition Audio device—to use the Microphone
jack or headphone/microphone combo jack of the docked computer
■ A dynadock Audio device—to use the headphone/microphone
combo jack of the dynadock
4. Click Set Default.
5. Click OK.
6. Connect your recording device to the jack you enabled in step 3.
Configuring Video Ports
Connection
The dynadock provides the following video ports:
HDMI – for connection to HDMI (using the HDMI cable which is not
provided) interface monitors. (up to 2560 x 1440 pixels)
DisplayPort – for connection to DisplayPort (using the DisplayPort
cable which is not provided) interface monitors. (up to 2560 x 1600
pixels)
Connect the monitor cable (not provided) to the video output port on the
dynadock and the external monitor. This cable can be connected and
disconnected any time without disconnecting the dynadock from your
computer.
You can customize the video settings of the dynadock. See section for more
information.
Viewable screens
The dynadock video drivers give you the option of viewing a total of four
screens:
■ the screen on the computer
■ an external monitor connected to the video port on the computer (if
available)
■ two external monitors connected to the dynadock
■ The icon ( ) appears in the system tray after connecting an external
display to the dynadock.
■ When using the DisplayPort and the HDMI out port simultaneously, the
resolution is up to 2048 x 1152 pixels.