User's Manual
Table Of Contents
- User誷 Manual
- Content
- Conventions
- Abbreviations
- Icons
- Safety icons
- Safety Instructions
- Do not disassemble, modify, tamper with or repair your product
- Handling the AC adaptor and power cables/cords or plugs
- Attaching the power cable/cord
- Dust on the power plug connectors or connector base
- Only use TOSHIBA AC adaptor
- Use correct power source
- Do not handle the power plug with wet hands
- Choking hazards
- Avoid liquids, moisture and foreign objects
- Never place your product or AC adaptor on a heat sensitive surface
- Never place your product in locations with excess heat
- Never place your product in a location with extremely low temperatures
- Never subject your product to sudden temperature variations
- Never operate your product during a thunderstorm
- Regulatory Statements
- Copyright Statement
- Disclaimer
- Trademarks
- TOSHIBA Support
- Precautions for Microsoft® Windows® 7 and Windows 8.1
- Introduction
- Quick Tour
- Using your dynadock for the first time
- Configuring Audio Ports
- Configuring Video Ports
- How Standby/Sleep/Hibernation Mode Affects Devices Attached to the dynadock
- Using the AP (Access Point) function
- Troubleshooting
- Specification
EN-22 User’s Manual
dynadock
TM
WiAC
To change the default settings, you might need to adjust the audio settings
in Windows
®
manually, as described in this section.
Configuring audio playback ports (Headphone)
1. Right-click the speaker icon in the Notification Area of your Windows
®
desktop.
(Sample Image) Speaker icon
2. Select Playback Devices from the menu.
3. On the Playback tab of the dialog box, select one of the following:
■ A Realtek High Definition Audio device—to use the Headphone/
Line out jack of the docked computer (The Realtek High Definition
Audio is provided with some computers.)
■ A dynadock Audio device—to use the Headphone/Microphone
combo jack of the dynadock
4. Click Set Default.
5. Click OK.
6. Connect your playback device to the jack you enabled in step 3.
■ If there is no audio device connected to the dynadock, the audio ports
on the computer are enabled automatically.
■ If your media player is running when you undock or dock, you must
close the application and wait approximately 10-15 seconds for the new
settings to take effect before restarting the application.
■ Audio devices connected to the dynadock via the 3.5 mm audio jack
appear as dynadock Audio device in Windows
®
.
■ When your computer is docked, SPDIF and Line in ports might display
in Windows
®
audio properties dialog boxes. These ports should appear
as “Currently unavailable” and are actually not provided by the
dynadock.
If the speaker icon is not visible in the Notification Area, access the audio
configuration utility through the following Start menu:
In Windows
®
7, click Start -> Control Panel -> Hardware and Sound ->
Sound.
In Windows 8.1, move the mouse pointer and click icon in the
lower-left corner of the screen to get to the Apps view, and then click
Control Panel -> Hardware and Sound -> Sound.
There might be other Audio devices listed in the menu depending on the
model of your computer.