User's Manual
Table Of Contents
- User誷 Manual
- Content
- Conventions
- Abbreviations
- Icons
- Safety icons
- Safety Instructions
- Do not disassemble, modify, tamper with or repair your product
- Handling the AC adaptor and power cables/cords or plugs
- Attaching the power cable/cord
- Dust on the power plug connectors or connector base
- Only use TOSHIBA AC adaptor
- Use correct power source
- Do not handle the power plug with wet hands
- Choking hazards
- Avoid liquids, moisture and foreign objects
- Never place your product or AC adaptor on a heat sensitive surface
- Never place your product in locations with excess heat
- Never place your product in a location with extremely low temperatures
- Never subject your product to sudden temperature variations
- Never operate your product during a thunderstorm
- Regulatory Statements
- Copyright Statement
- Disclaimer
- Trademarks
- TOSHIBA Support
- Precautions for Microsoft® Windows® 7 and Windows 8.1
- Introduction
- Quick Tour
- Using your dynadock for the first time
- Configuring Audio Ports
- Configuring Video Ports
- How Standby/Sleep/Hibernation Mode Affects Devices Attached to the dynadock
- Using the AP (Access Point) function
- Troubleshooting
- Specification
User’s Manual EN-21
dynadock
TM
WiAC
Disconnecting/Undocking your computer
There are several ways to disconnect/undock you computer:
■ Directly unplug the cable from the computer if it is connected.
■ While connecting the dynadock wirelessly, right-click the UDS icon in
the Notification Area of your Windows
®
desktop and select “Undock with
dynadockWiAC_xxxxxx”.
■ While connecting the dynadock wirelessly, click the Internet icon in the
Notification Area of your Windows
®
desktop and disconnect from
“dynadockWiAC_xxxxxx”.
Configuring Audio Ports
You can play back or record audio either through the audio port of the
dynadock or the docked computer. However, you cannot use the audio
ports on the docked computer and on the dynadock at the same time.
Upon docking connection, the audio port on the dynadock might become
enabled and the audio ports on the computer disabled. When you undock
the computer, the audio ports on the computer are re-enabled
automatically.
■ The name of the dynadock is displayed as “dynadockWiAC_xxxxxx”,
which differs from models.
■ Some computers might not immediately recognize that the dynadock is
connected upon start-up. This is related to the computers BIOS start up
sequence but not a malfunction of the dynadock. If this occurs, do the
following:
1. Turn off the computer
2. Disconnect the dynadock from the computer.
3. Turn the computer back on.
4. Connect the dynadock to the computer once the operating system
of the computer has loaded.
If a USB storage device is connected to the dynadock, make sure that you
save the data located on the USB device, and then remove the USB device
first before undocking.