User's Manual
Table Of Contents
- User誷 Manual
- Content
- Conventions
- Abbreviations
- Icons
- Safety icons
- Safety Instructions
- Do not disassemble, modify, tamper with or repair your product
- Handling the AC adaptor and power cables/cords or plugs
- Attaching the power cable/cord
- Dust on the power plug connectors or connector base
- Only use TOSHIBA AC adaptor
- Use correct power source
- Do not handle the power plug with wet hands
- Choking hazards
- Avoid liquids, moisture and foreign objects
- Never place your product or AC adaptor on a heat sensitive surface
- Never place your product in locations with excess heat
- Never place your product in a location with extremely low temperatures
- Never subject your product to sudden temperature variations
- Never operate your product during a thunderstorm
- Regulatory Statements
- Copyright Statement
- Disclaimer
- Trademarks
- TOSHIBA Support
- Precautions for Microsoft® Windows® 7 and Windows 8.1
- Introduction
- Quick Tour
- Using your dynadock for the first time
- Configuring Audio Ports
- Configuring Video Ports
- How Standby/Sleep/Hibernation Mode Affects Devices Attached to the dynadock
- Using the AP (Access Point) function
- Troubleshooting
- Specification
EN-18 User’s Manual
dynadock
TM
WiAC
Underside
The following illustration shows the underside of the dynadock. For a
description of each component, refer to the accompanying table.
(Sample Illustration) The underside of the dynadock
HDMI out port
HDMI out port can connect with Type A connector
HDMI cable (supports video and up to 5.1
surround sound). An HDMI cable sends video and
audio signals. In addition, it can send and receive
control signals.
DisplayPort
This port is for a connection to a DisplayPort
device.
Component Description
HDMI out port and DisplayPort can be used simultaneously for a dual
display.
1. Hook holes 2. Reset button
Component Description
Hook holes
These two holes allow you to mount the dynadock
to any other available place by using the provided
wall mount parts.
Reset button
Use a slender object (such as a pin) to press and
hold the reset button about 15 seconds until the
power indicator becomes quick-flash from slow-
flash. And then release the button and wait the
dynadock to reboot to its factory default settings.
11
2
Ensure the dynadock is powered on before it restarts completely.