User Manual

51
Getting Started
Adding memory (optional)
Installing a memory module with the computer’s power on may
damage the computer, the module, or both.
The computer has two memory slots—Slot A and Slot B. You can
install one or two memory modules.
Before you install or remove a memory module, turn off the computer
using the Start menu. If you install or remove a memory module
while the computer is in Sleep or Hibernation mode, data will be lost.
For this model, Slot A is the slot on the right-hand side of the
memory compartment, when looking from the front of the computer.
Slot B is the slot on the left-hand side. If only one memory module is
to be installed, it must be installed in Slot A.
If the computer is on, begin at step 1; otherwise, skip to step 3.
1 Click Start.
(Sample Image) Shut down button
2 Click the Shut down button in the lower-right corner of the
Start menu.
The computer closes all open programs, shuts down the
operating system, and then turns off.
3 Unplug and remove any cables connected to the computer,
including the AC adaptor.
4 Close the display panel and turn the computer upside down.
5 Remove the main battery. For information on removing the
main battery, see “Removing the battery from the computer”
on page 115.
NOTE
Shut down button Start button