User's Manual

7-4 User’s Manual
HW Setup
3. Use the left/right cursor keys to highlight the boot device you want and
press ENTER.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]Sets PXE as the protocol (Default).
[RPL]Sets RPL as the protocol.
HDD Priority Options
Set the priority of the HDD as a startup device.
USB Memory BIOS Support Type
Set the type of the USB memory as a startup device.
■ If a supervisor password is set only, it is the following.
■ The menu above appears (able to run HW Setup).
■ The menu above does not appear (unable to run HW Setup).
■ If the supervisor and user password are set, it is the following.
■ The menu above appears when you use the supervisor and user
password to start the computer (able to run HW Setup).
■ The menu above does not appear when you use the user password
to start the computer (unable to run HW Setup).
■ The menu above appears when you use the supervisor password
to start the computer (unable to run HW Setup).
■ The selection method above does not change the boot priority settings
in HW Setup.
■ If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in HW Setup.
Built-in HDD ->
USB
The priority is set as built-in HDD -> USB
memory (Default).
USB -> Built-in
HDD
The priority is set as USB memory -> built-in
HDD.
HDD Set the type of the USB memory to be equivalent
to the HDD (Default).
* Based on the [HDD] order in the [Boot Priority
Options] item. The order with respect to the other
HDD can be set in the [HDD Priority Options]
item.
FDD Set the type of the USB memory to be equivalent
to the FDD.
* Based on the [FDD] order in the [Boot Priority
Options] item.