User's Manual

Appendix A Setting Up TCP/IP

This section contains instructions for configuring the TCP/IP protocol of the Wireless LAN

Card. The IP address policy depends on your network. You should configure your TCP/IP

protocol as instructed by your network administrator.

For Windows 2000/XP

1. Double-click Network Dial-up Connections (Windows 2000) or Network Connections

(Windows XP) on Control Panel.

2. Right-click the Local Area Connection icon corresponding to your wireless adapter and

click Properties.

3. On the General tab, highlight Internet Protocol (TCP/IP) and then click Properties.

Option A: Use fixed IP address.

Enable the Use the following IP Address option. Enter the IP address, Subnet Mask

and Default gateway. Then click OK.

Option B: Use dynamic IP address