User's Manual

Setting up Profile Security
Data Encryption
WEP: WEP data encryption can be configured using 64-bit or 128-bit. WEP settings can be used with all
Network Authentication protocols.
When WEP encryption is enabled on an access point, the WEP key provides a way to verify access to
the network. If the wireless device does not have the correct WEP key, even though authentication is
successful, the device is unable to transmit data through the access point or decrypt data received from
the access point.
CKIP: Cisco Key Integrity Protocol (CKIP) is a Cisco proprietary security protocol for encryption in 802.11
media. Refer to
Security Overview for more information.
Enable 802.1x
Checked.
Step 1 of 2: WEP Key
Encryption Level
64-bit: 64-bit or 128-bit encryption.
Key Index
1,2,3,4: Up to four passwords may be specified by changing the Key Index.
Wireless Security Password (WEP Key)
Enter the wireless network Password (WEP Key) in the text box. The Password is the same value used
by the Wireless Access Point or Router. Contact your wireless network administrator for this password.
Pass phrase and hex key options are:
Pass phrase (64-bit): Enter 5 alphanumeric characters, 0-9, a-z or A-Z.
Hex key (64-bit): Enter 10 alphanumeric hexadecimal characters, 0-9, A-F.
Pass phrase (128-bit): Enter 13 alphanumeric characters, 0-9, a-z or A-Z.
Hex key (128-bit): Enter 26 alphanumeric hexadecimal characters, 0-9, A-F.
Step 2 of 2: MD5 User
Use the Windows logon user name and
password:
If this feature is selected the user’s credentials are retrieved from the user’s Windows Logon process.
Prompt for the user name and
password:
Prompts for a user name and password before you connect the wireless network. The user name and
password must be first set in the authentication server by the system administrator.
Use the following user name and
password:
The user name and password must be first set in the authentication server by the IT administrator.
User Name: This user name must match the user name that is set in the authentication server.
Password: This password must match the password that is set in the authentication server. The entered
password characters display as asterisks.
Confirm Password: Re-enter the user password.
file:///C|/CX2%20Muroc%20UG/6-15-04/wepsetup.htm (10 of 19) [6/15/2004 3:40:10 PM]