User's Manual

Access Point (Infrastructure) ModeAccess Point (Infrastructure) Mode
In access point (infrastructure) mode, the wireless network adapter participates in a
basic service set (BSS) as a station, and communicates with the other stations through
an AP, as illustrated here.
Access Point (Infrastructure) Mode
To connect to an Access Point network, configure the profile for Access Point mode.
Remove a Configuration Profile
To remove a configuration profile, select the profile to remove from the list of
configuration profiles on the Profile Management tab.
2. Click the Remove button.
TCP/IP Configuration
Configure the TCP/IP Address for the network device after configuring the wireless
network adapter properties.
Open the Control Panel and click Network and Dial-up Connections.
Find the Local Area Connection associated with the wireless network adapter.
Right-click that connection, and click Properties.
Select Internet Protocol (TCP/IP) and click Properties.
Click the radio button Use the following IP address, then enter an IP address and
Subnet mask. Assigning an IP address and Subnet mask allows stations to
operate in access point mode (infrastructure mode) and to have Internet access.