User Manual

User’s Manual 68
Hardware & Options Operation
Using TOSHIBA Network Attached Storage Utility
This utility is only for TOSHIBA Tablet NAS dock.
You are able to access TOSHIBA Tablet NAS Dock easily by using Network
Attached Storage Utility.
To launch Network Attached Storage Utility, tap Start → All Programs →
TOSHIBA → Utilities → TOSHIBA Network Attached Storage Utility.
Power indicator The Power indicator normally glows white when
the dock is turned on. However, this indicator will
glow orange while starting the dock.
Undock button Press this button to Undocking your device. For
details, please refer to Connecting the AC
adaptor section.
Power button Press this button to turn the dock on and off.
Universal Seral Bus
2.0 port
Four Universal Serial Bus ports, which comply to
the USB 2.0 standard, are provided.
DC IN 19V jack The AC adaptor connects to this jack in order to
power the device and charge its internal
batteries. Please note that you should only use
the model of AC adaptor supplied with the device
at the time of purchase - using the wrong AC
adaptor can cause damage to the device.
LAN jack This jack lets you connect to a LAN. The adaptor
has built-in support for Ethernet LAN (10
megabits per second, 10BASE-T), Fast Ethernet
LAN (100 megabits per second, 100BASE-TX).
Some models are equipped with a Gigabit
Ethernet LAN (1000 megabits per second,
1000BASE-T).
HDMI out port HDMI out port can connect with Type A
connector HDMI cable.
HDMI cable can send video and audio signals. In
addition to this, it can send and receive control
signals.
■ You must dock the device to a NAS Dock before you use TOSHIBA
Network Attached Storage Utility.
■ Refer to Using the TOSHIBA Tablet Dock section in this chapter for
details.