Instruction Manual
www.toseesecurity.com.au
Electronic Locking Button
When you push the button to the "red" status, the lock will
be in a "Locked" status and it can be only opened from
outside by Master Admin .
To disable this function, you need push the button to
"green" status, to release the "Locked" status.
Becareful as no user will be able to will be able to unlock
apart from the admin user, always leave a spare
mechanical key hidden outside for emergency.
Locked Unlock
1. You will need to reset the time after replacing the battery if not connected to Wi-Fi.
2.
The lock can be opened using default code 123456 followed by pressing # in trial mode.
3.
When the voltage is lower than 4.6V, the lock will automatically alarm every time. After the
alarm, the lock can be unlocked for 200 times. After that number of times, the delay time of
each lock opening will be 2 seconds.
4.
Passage mode: After unlocking in any way. Press "5" and then press "#", and the voice
prompt "passage mode, please pay attention to lock" is given to open passage mode. Enter
valid unlock information again. passage mode closed.
5. Keep the lock as close as possible to the wifi router.
6.
When the network is not good, the remote unlocking function and dynamic password
may become inconsitent or unavailable.
General Notes
7. On the WARDEN 1 (Entry Door Lock), to engage dead lock move door handle upwards.
8. Pressing and hold ing # key will sound a door bell chime.