Warranty

3
www.homewerksww.com
ASSEMBLY INSTRUCTIONS
9.
Connect a 1/2 in. IPS faucet
connector (not included) to the water
supplies underneath the sink using
wrenches (not included)
NOTE: Refer to the local plumbing
codes for permissible types of water
supply connectors.
9
10.
After the installation is complete,
turn on the water supply and allow
both hot and cold water to run for at
least one minute each. While the
water is running, check for leaks.
10
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Leaks underneath handle or from
the spout when the faucet is
turned off.
The bonnet nut is not tight enough.
The cartridge is damaged.
1. Remove the handle and retighten the bonnet nut.
2. If the problem occurs after retightening the bonnet nut, call customer service for a
new cartridge to replace the old one.
There is a leak from the spout
base when the faucet is on.
The o-ring which is on the connector under the
spout is worn.
1. Call customer service for a new o-ring and replace the old one.
CARE AND MAINTENANCE
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the nish and void your warranty.
ROUGH-IN
15-3/4"
1/2"-14NPSM-2A
7-3/4"
9-3/4"
6"
3-3/8"
9-1/4"
7-5/8"
MAX2"
MAX2"
2-1/8"
2-1/2"
4-3/8"