Warranty

3
www.homewerksww.com
ASSEMBLY INSTRUCTIONS
9.
Insert the lift rod (1) through the
faucet body (2) and into the lift rod
strap (3). Tighten the screw (4) on
the lift rod strap (3).
3
4
1
2
9
10.
After the installation is complete,
remove the aertator from the faucet
body (1) using a coin (not included).
Turn on the water supply and allow
both hot and cold water to run for at
least one minute each. While water
is running check for leaks. Replace
aerator.
A
10
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
There is a leak from under the
handle or there is a leak from the
spout when the faucet is off.
The bonnet nut is not tight enough.
The cartridge is damaged.
1. Remove the handle and retighten the bonnet nut.
2. If the problem occurs after the retightening the bonnet nut, call customer service for
a new cartridge and replace the old one.
There is a leak from the aerator
when the faucet is off.
The aerator does not t correctly on the faucet. 1. Reinstall the aerator.
2. Call customer service for a new aerator assembly and replace the old one.
The aerator had irregular or
reduced water ow.
The aerator is dirty. 1. Remove the aerator and clear debris.
CARE AND MAINTENANCE
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the nish and void your warranty.
ROUGH-IN
1/2"-14NPSM-2A
MAX1 1/4"
9-3/8"
2-5/8"
4-5/8"
6-1/2"
3-1/2"
5-1/2"