Warranty

2
www.homewerksww.com
PRODUCT SPECIFICATIONS
SPECIFICATIONS SPECIFICATIONS
Max. ow rate: 1.2 GPM (4.5 LPM) at 60 PSI Ceramic cartridge
ASME A112.18.1/CSA B125
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
NSF 61-9
Oil rubbed bronze nish
ASSEMBLY INSTRUCTIONS
1.
Shut off water supply and remove old
faucet.
NOTE: Each valve stop should be
turned clockwise.
1
5.
Apply silicone sealant (not included)
to the underside of the ange (1).
1
5
2.
Remove the preassembled mounting
nuts (1) from the faucet body (2) and
place the base plate (3) and faucet
body (2) in position on the sink.
NOTE: if the sink surface is uneven,
use silicone sealant (not included) to
create a watertight seal.
From under the sink, thread the
mounting nuts (1) onto the faucet
body (2). Tighten the mounting nuts
(1). Do not overtighten.
2
1
3
2
6.
Insert the pop-up assembly (1) into
the sink and screw the ange (2) onto
the pop-up assembly (1). Ensure the
pivot hole is facing the back of the
sink. Tighten the nut (3) and remove
the pivot nut (4).
2
1
3
4
6
3.
Connect a 1/2 in. IPS faucet connector
or coupling nuts (not included) with 3/8
in. O.D. ball-nose risers (not included)
to the water supplies underneath the
sink using wrenches (not included).
NOTE: Refer to the local plumbing
codes for permissible types of water
supply lines.
3
7.
Insert the stopper (1) onto the sink.
Remove the preassembled horizontal
rod (2) and clip from the lift rod strap
Install the horizontal rod (2) into the
pop-up assembly (3) and through the
hole of the stopper (1). Install the
pivot nut (4) onto the horizontal rod
(2) and hand-tighten it back onto the
pop-up assembly (3).
H
I
D
J
1
3
4
2
7
4.
Remove the stopper (1) and ange (2)
from the pop-up assembly (3). Screw
the nut (4) all the way down onto the
pop-up assembly (3) and then push
the gasket (5) down.
1
5
2
4
3
4
8.
Re-attach the lift rod strap (1) to the
horizontal rod (2) using the clip (3).
3
2
1
8