Installation Guide

2
www.homewerksww.com
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area where
new faucet will be mounted.
1
4. Attach spray head to goose-
neck hose. Hand tighten.
4
2. Insert spout into body making
sure the O-ring (2.1) snaps into
place. Hand tighten spout nut
(2.2) over body threads.
2.1
2.2
2
5. Re-connect supply lines. Turn
water supply or shut-off valve
back on and check for leaks. If
leaks occur, gently tighten union
nut and swivel union until leaks
stop.
5
3. Screw anges onto the ne
thread side of swivel unions, at
side facing away from faucet.
Use a wrench (not included) to
tighten swivel unions onto 1/2 in.
stub out pipes extending from
the wall. Insert rubber washer
into union nuts, then fasten to
body using union nuts attached
to the body.
Note: Do not overtighten.
3
6. IMPORTANT: Remove the
spray head by unscrewing it
from the goose neck hose in
a counterclockwise direction.
Be sure to hold the end of the
goose neck hose down into
the sink and turn the faucet on
to the warm position, where
it mixes hot and cold water.
Check for leaks. Re-tighten any
connections if necessary but do
not overtighten. Reinstall the
spray head by hand tightening it
back onto the goose neck hose.
6
PRODUCT SPECIFICATIONS
SPECIFICATIONS SPECIFICATIONS
Max. ow rate: 1.8 GPM (6,814 LPM) at 60 PSI Ceramic cartridges
ASME A112.18.1/CSA B125
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
NSF 61-9
Chrome and stainless steel Total weight of item: 5.75 lbs.
ASSEMBLY INSTRUCTIONS