User Instructions
Table Of Contents
- 1 Safety Instructions
- 2 Markings used
- 3 Application
- 4 Structure and mode of operation
- 5 Mechanical installation
- 5.1 Important precautions during installation
- 5.2 Conditions on site
- 5.3 Installation orientation
- 5.4 Installation
- 5.5 Preparing for the rotor mounting (exemplary)
- 5.6 Mounting the rotor
- 5.7 Installing the telemetry system
- 5.7.1 Measuring setup
- 5.7.2 Instruction for installation
- 5.7.3 Calibration signal
- 5.7.4 Stator antenna
- 5.7.5 Evaluation unit
- 6 Electrical connection
- 7 Shunt signal
- 7 Functional testing
- 8 Maintenance
- 9 Dimensions of the stator antenna
- 10 Dimensions of the rotor antenna
- 11 Specifications
26
Geschäftsführung: Thomas Lippok & Jens Wiegand • Aufsichtsratsvorsitzender: Joseph Vorih
Sitz der Gesellschaft: Darmstadt • Als Gesellschaft mit beschränkter Haftung eingetragen im Handelsregister des Amtsgerichts Darmstadt unter HRB 1147
Unser Unternehmen ist bei der Stiftung Elektro-Altgeräte Register (EAR) unter der Nummer WEEE-Reg.-Nr. DE66485129 registriert.
CONFIDENTIAL - EXTERNAL
7 Shunt signal
The special torque flange delivers an electrical shunt signal that can be
activated from the evaluation unit for measuring chains with HBM components.
The transducer generates a shunt signal of about 70-80% of the nominal (rated)
torque; the precise value is specified on the calibration certificate.
After activation of push button no. 6 or 15 (see Fig. 5.7 / 5.11), the shunt signal
is activated for a time span of 5s. Adjust the amplifier output signal to the shunt
signal supplied by the connected transducer to adapt the amplifier to the
transducer.
The transducer should not be under load when the shunt signal is being measured, as the
shunt signal is mixed additively.
Information