User Instructions
Table Of Contents
- 1 Safety Instructions
- 2 Markings used
- 3 Application
- 4 Structure and mode of operation
- 5 Mechanical installation
- 5.1 Important precautions during installation
- 5.2 Conditions on site
- 5.3 Installation orientation
- 5.4 Installation
- 5.5 Preparing for the rotor mounting (exemplary)
- 5.6 Mounting the rotor
- 5.7 Installing the telemetry system
- 5.7.1 Measuring setup
- 5.7.2 Instruction for installation
- 5.7.3 Calibration signal
- 5.7.4 Stator antenna
- 5.7.5 Evaluation unit
- 6 Electrical connection
- 7 Shunt signal
- 7 Functional testing
- 8 Maintenance
- 9 Dimensions of the stator antenna
- 10 Dimensions of the rotor antenna
- 11 Specifications
24
Geschäftsführung: Thomas Lippok & Jens Wiegand • Aufsichtsratsvorsitzender: Joseph Vorih
Sitz der Gesellschaft: Darmstadt • Als Gesellschaft mit beschränkter Haftung eingetragen im Handelsregister des Amtsgerichts Darmstadt unter HRB 1147
Unser Unternehmen ist bei der Stiftung Elektro-Altgeräte Register (EAR) unter der Nummer WEEE-Reg.-Nr. DE66485129 registriert.
CONFIDENTIAL - EXTERNAL
6.3 Use of EMI suppressor
To suppress high frequencies two EMI suppressors on the cable between rotor
and stator has to be used. Use at least 3 loops of the cable for the ring EMI
suppressor. The snap ferrites have to be mounted on the cable directly behind
the connector at the Axon control units.
Fastening must be done in an area not subject to mechanical loads (i.e. no
unwanted vibrations, etc.) using cable ties fit for the specific application.
Fig 6.1: Installation example EMI suppressor
Information
Consider longer cable of approximately 40cm due to the installation of the EMI
suppressor. The max. distance of EMI suppressor to connector is 500mm.
If the EMI suppressor has to be removed for any purpose (e.g. for
maintenance), it must be replaced on the cable. Use only EMI suppressor of
the correct type.