User Instructions
Table Of Contents
- 1 Safety Instructions
- 2 Markings used
- 3 Application
- 4 Structure and mode of operation
- 5 Mechanical installation
- 5.1 Important precautions during installation
- 5.2 Conditions on site
- 5.3 Installation orientation
- 5.4 Installation
- 5.5 Preparing for the rotor mounting (exemplary)
- 5.6 Mounting the rotor
- 5.7 Installing the telemetry system
- 5.7.1 Measuring setup
- 5.7.2 Instruction for installation
- 5.7.3 Calibration signal
- 5.7.4 Stator antenna
- 5.7.5 Evaluation unit
- 6 Electrical connection
- 7 Shunt signal
- 7 Functional testing
- 8 Maintenance
- 9 Dimensions of the stator antenna
- 10 Dimensions of the rotor antenna
- 11 Specifications
21
Geschäftsführung: Thomas Lippok & Jens Wiegand • Aufsichtsratsvorsitzender: Joseph Vorih
Sitz der Gesellschaft: Darmstadt • Als Gesellschaft mit beschränkter Haftung eingetragen im Handelsregister des Amtsgerichts Darmstadt unter HRB 1147
Unser Unternehmen ist bei der Stiftung Elektro-Altgeräte Register (EAR) unter der Nummer WEEE-Reg.-Nr. DE66485129 registriert.
CONFIDENTIAL - EXTERNAL
6 Electrical connection
The product offered is a special assembly for stationary systems that is not
available on the general market or a transducer for installation by system
integrators and plant manufacturers. According to EMVG1 §20 paragraph 2 and
Directive 2014/30/EU article 13 this product does not require an EC declaration
of conformity nor the CE marking.
This product is intended exclusively for subsequent processing by companies
or persons that are experts in the field of electromagnetic compatibility (EMC).
Relevant EMC protection requirements relating to the product offered are met
when the following Installation notes are observed and implemented.
Installation notes
Please note the following points during installation and use:
• It is essential to observe the specifications and notes provided in the
operating manual and the data sheet
• Connecting cables, in particular the measuring and control cables, need to be
shielded
• Make sure that the transducer and shielding are connected extensively to
ground.
• Ensure an interference-free environment, avoid radiation interference
• Devices connected to this product need to comply with protection
requirements per EMVG1. (Gesetz über die elektromagnetische
Verträglichkeit von Geräten / law on electromagnetic compatibility of
instruments).
You have to install the shield of the connection cable at the shielded housing of the
electronics, to achieve the EMC-protection of the measuring chain. Make sure that the
transducer and shielding are connected extensively to ground. It is important to cone
Important