operation manual
Table Of Contents
- 1 Einleitung
- 2 Geräteregistrierung
- 3 Ausstattung und Bedienelemente
- 4 Technische Daten
- 5 Sicherheit
- 6 Inbetriebnahme
- 7 Betrieb
- 8 Demontage des Antriebs
- 9 Trailern/Slippen des Bootes
- 10 Fehlermeldungen
- 11 Pflege und Service
- 12 Allgemeine Garantiebedingungen
- 13 Zubehör
- 14 Entsorgung und Umwelt
- 15 EG-Konformitätserklärung
- 16 Urheberrecht
- 1 Introduction
- 2 Registering the device
- 3 Equipment and controls
- 4 Technical data
- 5 Safety
- 6 Start-up
- 7 Operation
- 8 Disassembling the drive
- 9 Towing/slipping the boat
- 10 Error messages
- 11 Care and service
- 12 General conditions of warranty
- 13 Accessories
- 14 Disposal and environment
- 15 EC Declaration of Conformity
- 16 Copyright
Error messages
EN DE
10 Error messages
Drive system
Display Cause What to do
E02 Stator excess temperature (motor overheated) After waiting for a short period (approx. ten minutes), the motor can be
operated slowly again.
Contact Torqeedo Service.
E05 Motor/propeller blocked
1. Move the main switch to the “OFF” position.
2. Disconnect the battery connection.
3. Release the blockage.
4. Turn the propeller one more turn by hand.
5. Reconnect the battery to the system.
E06 Voltage to motor is too low Battery state of charge low; motor may possibly continue to be driven
slowly from the neutral position.
E07 Overcurrent to motor Continue at reduced power.
Contact Torqeedo Service.
E08 Circuit board excess temperature After waiting for a short period (approx. ten minutes), the motor can be
operated slowly again.
Contact Torqeedo Service.
page 93 / 112