operation manual
Table Of Contents
- 1 Einleitung
- 2 Geräteregistrierung
- 3 Ausstattung und Bedienelemente
- 4 Technische Daten
- 5 Sicherheit
- 6 Inbetriebnahme
- 7 Betrieb
- 8 Demontage des Antriebs
- 9 Trailern/Slippen des Bootes
- 10 Fehlermeldungen
- 11 Pflege und Service
- 12 Allgemeine Garantiebedingungen
- 13 Zubehör
- 14 Entsorgung und Umwelt
- 15 EG-Konformitätserklärung
- 16 Urheberrecht
- 1 Introduction
- 2 Registering the device
- 3 Equipment and controls
- 4 Technical data
- 5 Safety
- 6 Start-up
- 7 Operation
- 8 Disassembling the drive
- 9 Towing/slipping the boat
- 10 Error messages
- 11 Care and service
- 12 General conditions of warranty
- 13 Accessories
- 14 Disposal and environment
- 15 EC Declaration of Conformity
- 16 Copyright
Operation
DE EN
7.1 Emergency Stop
DANGER!
Risk of death if the Emergency Stop is not triggered!
Death or severe physical injuries may result.
■
Attach the cord on the magnetic kill switch to the skipper's wrist or to his life
jacket.
DANGER!
Risk of death from electromagnetic radiation!
Death or severe physical injuries may result.
■
Persons fitted with cardiac pacemakers must maintain a distance of at least
50 cm from the motor and the magnetic kill switch.
ADVICE
■
Test the functioning of the Emergency Stop switch at low motor power be-
fore every trip.
■
In emergency situations, actuate the Emergency Stop immediately.
■
At high power, use the Emergency Stop only in emergency situations. Re-
peated actuation of the Emergency Stop switch at high power stresses the
Travel system, and can cause damage to the battery electronics.
ADVICE
The magnetic kill switch can delete magnetic data media (especially credit cards,
bank cards, etc.). Keep the magnetic kill switch away from credit cards and other
magnetic data media.
There are various options for stopping the Travel system rapidly:
■
Place the tiller in the Stop position.
■
Pull off the magnetic kill switch.
■
Remove the motor cable from the battery.
ADVICE
If you have pulled out the magnetic kill switch, you must first bring the tiller han-
dle to the neutral position before continuing your trip. Then place the magnetic
kill switch in position. After a few seconds you can continue your trip.
page 84 / 112