operation manual

Start-up
EN DE
1
2
3
4
5
6
Fig. 52: Multifunction display – Set-up menu
1
Drive slowly
4
Stop
2
Charging
5
Temperature
3
GPS searching
6
Error
Drive
slowly (1)
Displayed when the battery capacity is <30 %. Three beeps will
sound. The beep will sound again once the state of charge drops
below 20 % and 10 %.
Charging (2)
Displayed during charging.
GPS
searching (3)
The integrated GPS module searches for satellite signals in order to
calculate speed. If no GPS signal is received, then the second field
of the display continuously shows the "Remaining run time at cur-
rent speed" (time value) and a clock symbol. If the remaining run
time is greater than 10 hours, then the remaining run time is dis-
played in complete hours. If it is less than this, then hours and min-
utes are displayed.
The GPS module stops searching if no signal is received for five
minutes. In order to reactivate the search, the system must be
switched off and on again using the On/Off button.
Stop (4)
This symbol appears if the tiller handle needs to be placed in the
neutral position. This is necessary before you can move off.
Temperature
(5)
This symbol appears in case of excess temperature of the motor or
battery. In this case, the motor itself reduces the power indepen-
dently.
Error (6) In the event of an error, the Error symbol appears in the bottom
box, and an error code is displayed. The code indicates the compo-
nent which triggered it, and also the component error. Details of
the error codes are found in Chapter 10, "Error messages".
page 81 / 112