operation manual

Start-up
EN DE
6.3 Trimming the motor
1
2
3
Fig. 48: Trimming positions
1
Additional trimming positions
3
Securing cotter pin
2
Trim rod
Trimming allows the motor to be positioned optimally relative to the water surface.
For this purpose, four trimming positions (1) are available.
In order to position the motor optimally relative to the water surface, proceed as fol-
lows:
1.
Tilt the motor upwards; see Chapter 7.3, "Tilting the motor".
2. Remove the securing cotter pin (3) of the trim rod (2), and pull the trim rod (2)
out of the transom bracket.
3. Insert the trim rod (2) in the desired trimming position (1) of the transom brack-
et.
The trim rod (2) must be pushed through both side walls of the transom
bracket.
4. Fix the trim rod (2) using the securing cotter pin (3).
page 77 / 112