operation manual
Table Of Contents
- 1 Einleitung
- 2 Geräteregistrierung
- 3 Ausstattung und Bedienelemente
- 4 Technische Daten
- 5 Sicherheit
- 6 Inbetriebnahme
- 7 Betrieb
- 8 Demontage des Antriebs
- 9 Trailern/Slippen des Bootes
- 10 Fehlermeldungen
- 11 Pflege und Service
- 12 Allgemeine Garantiebedingungen
- 13 Zubehör
- 14 Entsorgung und Umwelt
- 15 EG-Konformitätserklärung
- 16 Urheberrecht
- 1 Introduction
- 2 Registering the device
- 3 Equipment and controls
- 4 Technical data
- 5 Safety
- 6 Start-up
- 7 Operation
- 8 Disassembling the drive
- 9 Towing/slipping the boat
- 10 Error messages
- 11 Care and service
- 12 General conditions of warranty
- 13 Accessories
- 14 Disposal and environment
- 15 EC Declaration of Conformity
- 16 Copyright
Start-up
DE EN
1. Connect the motor cable (9) to the motor cable connector (10).
2. Tighten the union nut on the motor cable.
3. Connect the tiller cable (7) to the tiller cable connector (8).
4. Tighten the union nut of the tiller cable.
6.2 Fixing the steering in place
1
Fig. 47: Small fixing pin position
1
Small fixing pin
The small fixing pin (1) can be used to prevent the motor from making steering
movements. The boat can then be steered via the rudder (e.g. with sailboats). Lock-
ing the steering is optional.
1. Remove the battery.
2. Push the small fixing pin (1) into the opening provided for it.
3.
Install the battery; see description Chapter 6.1, "Installation of the drive to the
boat".
page 76 / 112